CLEAR CUT
STRIPPER
NON-AMMONIATED WAX
STRIPPING CONCENTRATE
LOW ODOR FORMULA
IDEAL FOR USE IN
HEALTH CARE AND FOOD
PREPARATION FACILITIES

DIRECTIONS FOR USE
CLEAR CUT STRIPPER has been carefully
formulated to be used as an integral part of
scrub and rinse floor stripping program.
Dust mop entire floor to remove loose dust and
dirt. Prepare a stripping solution by diluting 8 to
16 ounces of CLEAR CUT STRIPPER per gallon
of warm water. Recommended dilution rates are
based upon floors with an accumulation of 10
coats of applied floor finish. To ensure proper
solution strength, apply diluted product to a
small area of floor. If stripping solution does not
cut through all accumulated finish, add more
CLEAR CUT STRIPPER. Flood floor with
stripping solution with a wet mop. Allow the
stripping solution to remain on the floor for 5 to
10 minutes.
Do not allow stripping solution to dry on floor.
Scrub with a 175 - 300 rpm rotary floor
machine equipped with a black stripping pad. If
an autoscrubber is to be used, two passes are
recommended to complete the scrubbing
process. Pick up the stripping/finish residue with
a wet vac or autoscrubber. To rinse, flood floor
with clean cool water. Pick up with wet vac or
autoscrubber. Complete rinsing process by
damp mopping with clean, cool water and a
clean mop.

PROFESSIONAL SECRETS TO
EFFECTIVE FLOOR CARE:
• Stripping solution should always be prepared
just prior to use.
• Always dry mop before starting any stripping
operation - Unremoved dirt and dust can
damage floors during scrubbing operations.
• When scrubbing with a rotary scrubber, be
certain to overlap passes to cover the entire
floor. Walk only where you’ve scrubbed - It’s
less slippery.
• To prevent clogging, flip pads frequently. To
keep pads in peak operating condition, clean
with a dilute solution of stripper and store in
a plastic bag.