TUBERCULOCIDAL • CLEANER • DEODORIZER • DISINFECTANT
MILDEWSTAT (on hard inanimate surfaces)
FUNGICIDE (against pathogenic fungi) & *VIRUCIDE

DIRECTIONS FOR USE
It is a violation of Federal Law to use this product in a manner
inconsistent with its labeling.
This product is not for use on critical or semi-critical medical device
surfaces.
This product is designed specifically as a general non-acid cleaner
and disinfectant for use in homes, nursing homes, hospitals, patient
rooms, operating rooms, ICU areas, shower rooms, locker rooms,
public restrooms, schools, transportation terminals, office buildings,
manufacturing facilities, lodging establishments, retail businesses and
athlete/recreational facilities where housekeeping is of prime
importance in controlling the hazard of cross contamination. It is
formulated to disinfect hard, non-porous, inanimate environmental
surfaces: floors, walls, metal surfaces, stainless steel surfaces, glazed
porcelain, glazed ceramic tile, plastic surfaces, chrome, brass, copper,
laminated surfaces, baked enamel surfaces, bathrooms, shower
stalls, bathtubs, and cabinets. For plastic and painted surfaces, spot
test on an inconspicuous area before use. May be used in the kitchen
on counters, sinks, appliances, and stovetops. A rinse with potable
water is required for surfaces in direct contact with food. In addition,
this product deodorizes those areas that generally are hard to keep
fresh smelling, such as garbage storage areas, empty garbage bins
and cans, basements, restrooms and other areas which are prone to
odors caused by microorganisms.
Cooling Coils Disinfectant Cleaner: This product is a ready-to-use,
non-abrasive, one-step disinfectant cleaner for small air conditioner,
commercial air handling unit, and HVAC cooling coils and refrigeration
equipment, refrigerator, and freezer evaporation coils. When using
this product to disinfect and clean cooling coils and evaporation coils.
Disconnect power to the unit before applying product.
DISINFECTION, DEODORIZING AND CLEANING - Remove gross filth
or heavy soil prior to application of the product. Hold container 6 to
8 inches from surface to be treated. Spray area until it is covered with
the solution. Allow product to penetrate and the surface to remain
wet for 3 minutes. (for Bloodborne Pathogens: allow surface to
remain wet for HIV-1 1 minute and for HBV and HCV 5 minutes). No
scrubbing is necessary. Wipe off with a clean cloth, mop or sponge.
The product will not leave grit or soap scum.
One-step cleaning and disinfection of toilet bowls and urinals:
Remove water from bowl by forcing water over trap with a swab mop
applicator. Press swab mop against side of the bowl to remove
excess water from applicator. Apply 1 to 2 ounces of this product
evenly, allowing sufficient time for product to cover entire surface of
bowl for maximum cleaning. Swab bowl completely using a scrub
brush or toilet mop, making sure to get under the rim. Let stand for
3 minutes (for Bloodborne Pathogens: allow surface to remain wet
for HIV-1 1 minute and for HBV and HCV 5 minutes) and flush.
Using approved AOAC test methods (under Good Laboratory
Practices, [GLPs]), in the presence of 5% blood serum and a 3 minute
contact time, unless otherwise noted, this product kills the following
organisms on hard non-porous inanimate surfaces.