CRYSTAL
DURABLE METAL
CROSS-LINKED ACRYLIC
FLOOR FINISH
HIGH RESPONSE
TO SPRAY BUFFING
(175-1000 RPM) PROGRAMS
COMBINES EXCEPTIONAL GLOSS,
DURABILITY AND REPAIRABILITY
IN A SINGLE FINISH

DIRECTIONS FOR USE
This product has been designed to meet today’s
demand for a versatile floor care system that
combines good looks, superior durability with ease of
maintenance. This “goof-proof” finish applied easily -
no mop drag. Its unique polymer design provides
unparalleled responsiveness to spray buffing
operations. For best results, apply a minimum of two
coats to a floor previously sealed with a high quality
floor sealer
.
Always apply to a floor sealed with a high quality floor
sealer. With a clean, rayon/cotton blend mop, apply
this product by first “framing” the area to be finished.
Use mop to apply a line of seal around the area to be
sealed, then go back and fill in the “framed” area with
a gentle side to side mopping motion, being certain to
overlap each pass slightly. If a rectangular finish
applicator is being used. Be certain, that the
applicator head has been thoroughly rinsed. Apply
seal in thin, unbroken line, be certain that each pass
slightly overlaps the previous one. Let each coat dry
to the touch before recoating. Dry time is
approximately 30 minutes. High humidity could
prolong dry time. A fan can be used to reduce drying
time. Allow the seal to set for 10 minutes before
starting a fan. Do not use a fan in areas where dust
could be blown onto sealer. Apply each subsequent
coat using the same method outlined above. Floors
subject to spray buffing operations, apply a minimum
of two coats of floor finish.
MAINTENANCE OF FLOOR FINISH: Dust mop daily
using a mop treated with a dust mop treatment. Dirt
and dust can abrade and scratch your finishes
destroying their natural luster. Damp mop regularly.
The highest gloss come only from clean floors. Dirt
acts as a barrier to light reflection, causing your
floors to look dull and lifeless. To restore lost luster,
burnish regularly. Mop on a luster restorer before
using Ultra High Speed (UHS) burnisher will bring
back that spectacular “wet look” shine.
To restore lost shine, spray buff at least twice per
week.This product repairs marks, deep scuffs and
scratches quickly. When used in a regular spray
buffing program, it helps floor finishes to “snap back”
to their original luster to extend finish life and
eliminate time consuming recoating.

PROFESSIONAL SECRETS TO
EFFECTIVE FLOOR CARE:
• To ensure that this product reaches its maximum
gloss potential, always apply to floors with at least
two coats of a floor seal. Maximum gloss can only be
achieve on smooth, level floors. Floor sealers smooth
out your floors surface imperfections to allow for
maximum light reflectance.
• Do not use your stripping or rinsing mop or bucket
for the application of floor finishes. Always start with
a clean, previously wrung-out cotton/rayon mop and
bucket. Save this mop and bucket just for the
application of finish.
• Always apply even, medium coats. To ensure the
application of medium coats, wring out the bottom
half of a fully saturated mop.
• Discard unused finish. Pouring unused finish from
your bucket back into the original container can spoil
the good finish .