DIRECTIONS FOR USE
DAZZLE FLOOR FINISH utilizes a unique combination of
synthetic polymers to produce a floor finish that can
withstand the rigors of frequent burnishing. Designed for
easy maintenance of its incredible “wet look” gloss, DAZZLE
FLOOR FINISH displays superior scratch and scuff resistance
significantly reducing the frequency of restoration and
recoating operations. For best results, apply a minimum of
two coats of DAZZLE FLOOR FINISH to a floor previously
sealed with FIRST REFLECTION or DIAMOND SEAL FLOOR
SEALERS.
Always apply DAZZLE FLOOR FINISH to a floor sealed with
FIRST REFLECTIONS or DIAMOND SEAL FLOOR SEALERS.
With a clean, rayon/cotton blend mop, apply DAZZLE by first
“framing” the area to be finished. Use mop to apply a line
of seal around the area to be sealed, then go back and fill in
the “framed” area with a gentle side to side mopping
motion, being certain to overlap each pass slightly. If a
rectangular finish applicator is used. Be certain, that the
applicator head has been thoroughly rinsed. Apply seal in
thin, unbroken line, be certain that each pass slightly
overlaps the previous one. Let each coat dry to the touch
before recoating. Dry time is approximately 30 minutes. High
humidity could prolong dry time. A fan can be used to
reduce drying time. Allow the seal to set for 10 minutes
before starting a fan. Do not use a fan in areas where dust
could be blown onto sealer.
Apply each subsequent coat of DAZZLE FLOOR FINISH using
the same method outlined above. For maintenance of “wet
look” gloss, burnish frequently with an UHS Electric, Battery
or Propane burnisher.
MAINTENANCE OF DAZZLE FLOOR FINISH: Dust mop daily
- using dust mops treated with FIRST ATTRACTIONS DUST
MOP TREATMENT. Dirt and dust can abrade and scratch
your finishes destroying their natural luster. Damp mop
regularly with EXCEL FLOOR CLEANER. The highest gloss
come only from clean floors. Dirt acts as a barrier to light
reflection, causing your floors to look dull and lifeless. To
restore lost luster, burnish regularly.
Mop on LUSTRE RESTORER before using Ultra High Speed
(UHS) burnisher will bring back that spectacular “wet look”
shine. To restore lost shine, spray buff at least twice per
week. CRYSTAL IMAGE SPRAY BUFF LIQUID repairs marks,
deep scuffs and scratches quickly. When used in a regular
spray buffing program, it helps floor finishes to “snap back”
to their original luster to extend finish life and eliminate time
consuming recoating.
PROFESSIONAL SECRETS TO
EFFECTIVE FLOOR CARE
• To ensure DAZZLE reaches its maximum gloss potential,
always apply to floors with at least two coats of a floor seal,
like FIRST REFLECTIONS. Maximum gloss can only be
achieved on smooth, level floors. Floor sealers smooth out
your floors surface imperfections to allow for maximum light
reflectance.
• Do not use your stripping or rinsing mop or bucket for the
application of floor finishes. Always start with a clean,
previously wrung-out cotton/rayon mop and bucket. Save
this mop and bucket just for the application of finish.
• Always apply even, medium coats. To ensure the
application of medium coats, wring out the bottom half of a
fully saturated mop.
• Discard unused finish. Pouring unused finish from your
bucket back into the original container can spoil the good
finish.

DAZZLE
FLOOR FINISH
HIGH SOLIDS BURNISHING
FLOOR FINISH
REACTIVE POLYMER
MATRIX MAXIMIZES
BURNISHING RESPONSIVENESS
COMBINES SUPERIOR
“WET LOOK” GLOSS WITH
INCREDIBLE DURABILITY