DIAMOND SEAL
FLOOR SEALER
WATER-BASED URETHANE
FORTIFIED FLOOR SEALER
SPECIFICALLY FORMULATED
FOR MAXIMUM ADHERENCE TO
TERRAZZO AND POROUS
STONE FLOORING
SUPERIOR BASE COAT FOR ACRYLIC
FINISHES SUBJECTED TO
EITHER BURNISHING OR
SPRAY BUFFING OPERATIONS

DIRECTIONS FOR USE:
DIAMOND SEAL FLOOR SEALER has been specially
formulated to solve the problem associated with the
maintenance of terrazzo and other porous stone
flooring. This unique sealer establishes a reversible
bond with stone surfaces to ensure superior
adherence. Urethane modifiers give the acrylic matrix
incredible strength and durability. Making DIAMOND
SEAL an excellent base for the application of high
gloss acrylic floor finishes, like DAZZLE, JEWEL and
CRYSTAL. Two coats of DIAMOND SEAL levels
flooring surface imperfections to maximize the gloss
potential of your floor finish.
Always apply DIAMOND SEAL to a newly stripped
floor. With a clean, rayon/cotton blend mop, apply
DIAMOND SEAL by first “framing” the area to be
finished. Use mop to apply a line of seal around the
area to be sealed, then go back and fill in the
“framed” area with a gentle side to side mopping
motion, being certain to overlap each pass slightly.
If a rectangular finish applicator is used, be certain
that the applicator head has been thoroughly rinsed.
Apply seal in thin, unbroken line, be certain that each
pass slightly overlaps the previous one. Let each coat
dry to the touch before recoating. Dry time is
approximately 30 minutes. High humidity could
prolong dry time. A fan can be used to reduce drying
time. Allow the seal to set for 10 minutes before
starting a fan. Do not use a fan in areas where dust
could be blown onto sealer. Apply a second coat of
DIAMOND SEAL using the same method outlined
above.
After 30 minutes begin applying high gloss floor
finishes (i.e. DAZZLE, JEWEL and CRYSTAL). For
floor subject to burnishing operation, apply a
minimum of four coats of finish. Floors subject to
spray buffing operations, apply a minimum of two
coats of floor finish.
PROFESSIONAL SECRETS TO EFFECTIVE FLOOR CARE:
• Do not use your stripping or rinsing mop or bucket
for the application of floor sealers. Always start with
a clean, previously wrung-out cotton/rayon mop and
bucket. Save this mop and bucket just for the
application of sealer.
• To avoid the accumulations of finish build-up in
corners or on baseboards, always the first coat of
DIAMOND SEAL no closer than 12 inches from
baseboards. Apply second and every other coat up to
baseboards.
• Always apply even, medium coats. To ensure the
application of medium coats, wring out the bottom
half of a fully saturated mop.
• Discard unused finish. Pouring unused finish from
your bucket back into the original container can spoil
the good finish.