JEWEL
FLOOR FINISH
HIGH PERFORMANCE -
LOW MAINTENANCE
20% NON-VOLATILE METAL
CROSS-LINKED ACRYLIC SOLIDS
EXCEPTIONALLY DURABLE GLOSS
UNDER ALL TRAFFIC CONDITIONS

DIRECTIONS FOR USE:
JEWEL has been specially formulated with a unique polymer
blend for exceptional toughness and durability. This lower
maintenance finish displays superior scratch and scuff
resistance significantly reducing the frequency of restoration
and recoating operations. JEWEL has been developed to
meet today’s demand for performance with excellent
responsiveness to both burnishing or spray buffing
operation.
For best results, apply a minimum of two coats of JEWEL to
a previously sealed with FIRST REFLECTION OR DIAMOND
SEAL. Always apply JEWEL to a floor sealed with FIRST
REFLECTIONS or DIAMOND SEAL. With a clean,
rayon/cotton blend mop, apply JEWEL by first “framing” the
area to be finished. Use mop to apply a line of seal around
the area to be sealed, then go back and fill in the “framed”
area with a gentle side to side mopping motion, being
certain to overlap each pass slightly. If a rectangular finish
applicator is used. Be certain, that the applicator head has
been thoroughly rinsed. Apply seal in thin, unbroken line, be
certain that each pass slightly overlaps the previous one.
Let each coat dry to the touch before recoating. Dry time is
approximately 30 minutes. High humidity could prolong dry
time. Allow the seal to set for 10 minutes before starting a
fan. Do not use a fan in areas where dust could be blown
onto sealer. Apply each subsequent coat of JEWEL using the
same method outlined above. For floor subject to burnishing
operation, apply a minimum of four coats of JEWEL. Floors
subject to spray buffing operations, apply a minimum of two
coats of JEWEL.
MAINTENANCE: Dust mop daily - using dust mops treated
with FIRST ATTRACTIONS. Dirt and dust can abrade and
scratch your finishes destroying their natural luster. Damp
mop regularly with EXCEL. The highest gloss come only
from clean floors. Dirt acts as a barrier to light reflection,
causing your floors to look dull and lifeless.
To restore lost luster, burnish regularly. Mop on LUSTRE
RESTORER before using Ultra High Speed (UHS) burnisher
will bring back that spectacular “wet look” shine. To restore
lost shine, spray buff at least twice per week. CRY S TAL
IMAGE repairs marks, deep scuffs and scratches quickly.
When used in a regular spray buffing program, it helps floor
finishes to “snap back” to their original luster to extend
finish life and eliminate time consuming recoating.