LUSTRE
RESTORER
MOP-ON FLOOR
UHS RESTORER CONCENTRATE
REACTIVE POLYMER MATRIX
RESPONDS TO BURNISHING TO
RECREATE “WET LOOK” SHINE
RENEWS SURFACES
REPAIRS SCRATCHES AND MARKS

DIRECTIONS FOR USE: LUSTRE RESTORER
has been precision formulated to match the
composition of CRYSTAL Floor Finish. Its
unique Reactive Polymer Matrix (RPM) utilizes
the heat produced by Ultra High Speed (UHS)
burnishing equipment to create a spectacular,
highly reflective “wet look” gloss. A daily
burnishing program, featuring LUSTRE
RESTORER, repairs scratches and marks,
enhances finish durability and extends finish life.
1. Dry mop the entire floor using a dust mop
treated with CLEAR ATTRACTIONS Dust Mop
Treatment to remove loose soil.
2. Clean floor with a damp mop or an
autoscrubber using EXCEL CLEANER
following label directions.
3. Dilute 2 to 4 ounces of LUSTRE RESTORER
per gallon of warm water.
MOP APPLICATION: Mop on a medium, even
coat of LUSTRE RESTORER solution, being
certain to cover all areas of floor. Allow to dry to
a slight haze (approximately 20 to 30 minutes).
Burnish with a white or beige pad using your
electric, battery or propane powered UHS
machine.
AUTOSCRUBBER APPLICATION: Mix LUSTRE
RESTORER in autoscrubber tank (approximately
1/2 gallon into a 14 gallon tank). Scrub with a
red pad. Pick up solution with vacuum.
Damp mop to pick-up all puddles. Allow to dry
to a slight haze (approximately 5 to 10 minutes).
Burnish with a white or beige pad using your
electric, battery or propane powered UHS
machine.
PROFESSIONAL SECRETS
TO EFFECTIVE FLOOR CARE
1. Floors should be dust mopped and damp
mopped before spray buffing - accumulated
dust and dirt cause unsightly scratches or
abrasion that will significantly reduce finish
durability and lead to frequent stripping and
recoating.
2. Inspect pads frequently. If pads show an
accumulation of old floor finish, dirt or
accumulated restorer solution in the space
between pad fibers, clean or replace
immediately.